- This topic has 2 replies, 2 voices, and was last updated 19 years, 9 months ago by
denverdoc.
denverdoc.Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
denverdoc
I am fuming. For 2 months I have tried to get a replacement for a bad board–the serial/usb conversion I was sent from aerocon had the header flipped and despite promises to replace g-wiz has not delivered. Anyone have a board whose attending LDRS or could help be rig a straight serial connector, be much indebted,
John SKen Plattner
I might be able to help. Is there an RS-232 connector on the board. If so, it should be fairly easy to wire a cabel to a 9 pin connector if you have the schematic or wiring diagram for the RS-232 interface. When are you leaving for TX?
denverdoc
xman,
Thanks, I got it covered as someone at LDRS has the right cabling.
John
denverdoc
Ken PlattnerViewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.