- This topic has 10 replies, 6 voices, and was last updated 17 years, 8 months ago by
djsroc.
djsroc.-
Posts
-
djsroc
Does anyone have (2) 3″ loc tubing couplers they can part with? I dont think ill have enough time to order some and get e-bay done in time for MHM. Im trying to modify my L1 rocket to add electronics and do my L2 on same day.
Also need to borrow a AT 38mm case for a J350. I have 54mm hardware for collateral if needed.
Its no big deal if no one has these parts, ill just do my re-cert L1 at MHM and my L2 next month with my new project.
edward
I’m going to look in my basement. I know I’ve got at least one. I’ll post again tonight after I look.
Edward
Warren B. Musselman
You don’t need electronics or dual deploy to get your L2… you can fly it on motor ejection no problem.
Warren
djsroc
Warren, so very true but I really dont want to walk to the next county to recover it 😀 Ive had to walk over 2 miles for this rocket on an I300 before. Guess Im getting lazy in my old age, hehe.
James Russell
I think I have one, will look and let you know
James Russell
All I could find was PML and AT coupler tubing. I really thought I had one but not were I thought I put it. You may check with HT but not sure if they would have it being that Joe is not there. I have only been in the Westminster store, their rocket stuff is a lot smaller area then it was.
Ken Plattner
I have plenty of PML coupler tubing I could cut to length if you need it.
Ken
Bruce R. Schaefer
I’ve got a 38/720 casing and closures you can use. I might even clean it for you. No collateral needed, just the standard rule: you break it, you buy it. 😉
edward
I’ve got a 3″ PML coupler. The Hobby Town in Fort Collins didn’t have any last I looked. Their selection was poor.
You are welcome to the coupler.
Edward
Ken Plattner
Doug, I sent you a couple of PM’s but I don’t know if they went through. Let me know if you didn’t get them. I have the tube, so lets figure out how to hook up in Longmont.
Ken.
djsroc
edward
Warren B. Musselman
James Russell
Ken Plattner
Bruce R. Schaefer
- You must be logged in to reply to this topic.