Fin Design

This topic has 0 replies, 1 voice, and was last updated 12 years, 4 months ago by Douglas Krohn.

Viewing 1 post (of 1 total)

Author

Posts
May 8, 2013 at 3:18 pm #41654
Douglas Krohn
Is there any consensus of most efficient fin geometry design in the Mach 1-2 region at the higher altitudes. I want to build a sustainer that would fly in that range starting at about 15-20k ft. Not worried as much about fin flutter at uber high speeds. Any suggestions?

Thx

Doug Krohn
L3
Author

Posts

Viewing 1 post (of 1 total)

The forum ‘Archives 2013’ is closed to new topics and replies.

2019-06-01 MHM DAY 2-3 077

✕

We are Good to Go with our scheduled and approved launch on Saturday April 5th and Sunday April 6th, from the North Site, subject to change – Mostly cloudy and High Winds predicted. Range and waiver should be active by 9AM on Saturday. The Pawnee National Grassland remains fragile and dry, so extra precautions are in order. Please stay on the authorized roads and please don’t park more than 100’ off the road at the flight line.