Need ASAP!

[djsrocKeymaster]

Does anyone have (2) 3″ loc tubing couplers they can part with? I dont think ill have enough time to order some and get e-bay done in time for MHM. Im trying to modify my L1 rocket to add electronics and do my L2 on same day.

Also need to borrow a AT 38mm case for a J350. I have 54mm hardware for collateral if needed.

Its no big deal if no one has these parts, ill just do my re-cert L1 at MHM and my L2 next month with my new project.

[edwardModerator]

I’m going to look in my basement. I know I’ve got at least one. I’ll post again tonight after I look.

Edward

[Warren B. MusselmanModerator]

You don’t need electronics or dual deploy to get your L2… you can fly it on motor ejection no problem.

Warren

[djsrocKeymaster]

Warren, so very true but I really dont want to walk to the next county to recover it 😀 Ive had to walk over 2 miles for this rocket on an I300 before. Guess Im getting lazy in my old age, hehe.

[James Russell]

I think I have one, will look and let you know

[James Russell]

All I could find was PML and AT coupler tubing. I really thought I had one but not were I thought I put it. You may check with HT but not sure if they would have it being that Joe is not there. I have only been in the Westminster store, their rocket stuff is a lot smaller area then it was.

[Ken PlattnerParticipant]

I have plenty of PML coupler tubing I could cut to length if you need it.

Ken

[Bruce R. Schaefer]

I’ve got a 38/720 casing and closures you can use. I might even clean it for you. No collateral needed, just the standard rule: you break it, you buy it. 😉

[edwardModerator]

I’ve got a 3″ PML coupler. The Hobby Town in Fort Collins didn’t have any last I looked. Their selection was poor.

You are welcome to the coupler.

Edward

[Ken PlattnerParticipant]

Doug, I sent you a couple of PM’s but I don’t know if they went through. Let me know if you didn’t get them. I have the tube, so lets figure out how to hook up in Longmont.

Ken.

[Author]

Posts